[an error occurred while processing this directive]
|
ногах хост-порта. Кстати у меня вот есть два даташита. В первом, более старом:
For proper device operation, the HD12 pin must be externally pulled down with a 1-kΩ resistor.
Во втором:
For a C6713BGDP:
− Big Endian Mode Correctness EMIFBE (HD12) [C6713B only]
0 – The EMIF data will always be presented on the ED[7:0] side of the bus, regardless of the endianess mode (Little/Big Endian).
1 − In Little Endian mode (HD8 =1), the 8-bit or 16-bit EMIF data will be present on the ED[7:0] side of the bus.
In Big Endian mode (HD8 =0), the 8-bit or 16-bit EMIF data will be
present on the ED[31:24] side of the bus [default]. For a C6713BPYP, when Big Endian mode is selected (LENDIAN = 0), for proper device operation the EMIFBE pin must be externally pulled low.
This enhancement is not supported on the C6713 device. For proper C6713 device operation, do not oppose the internal pullup (IPU) resistor on this pin. This new functionality does not affect systems using the current default value of HD12=1.
Так что "думайте сами, решайте сами" что делать с HD12 :)))))))
E-mail: info@telesys.ru