|
|
This utility is named `XDSPROBE'.
It is used to probe scan-controllers and scan-paths.
It uses Release-3 of the Unified-SCIF stack.
It is version `3.03.00'.
It is dated `Jul 24 2001'.
It is Copyright (c) 1990-2001 by Texas Instruments Incorporated.
This utility has determined the operating system is WinXP.
The operating system has Service Pack 2 installed.
---[Open the controller]----------------------------------------
The IO port address 0x240 will be used.
Requesting Unified-SCIF to detect and open the controller.
The controller has been detected and opened successfully.
---[The scan-path lengths of TI DSP's and microcontrollers]-----
The JTAG IR register for a ARM7 or ARM9 device has 4 bits.
The JTAG IR register for a `classic' TI DSP device has 8 bits.
The JTAG IR register for a `IceMaker' TI DSP device has 38 bits.
The JTAG IR register for a C621x or C671x device has 46 bits.
The older TI DSP devices with `classic' emulation
include the C4x, C5x, C8x, C20x, C24x products.
The newer TI DSP devices with `classic' emulation
include the VC33, C54x, C620x and C670x products.
The TI DSP devices with `IceMaker' emulation
include the C27x, C28x, C55x and C64x products.
---[Perform the scan-path length test on the JTAG IR and DR]----
Allocated 0x800 words of scan-controller memory, base 0x0
Changed the JTAG state to Test-Logic-Reset.
The test for the JTAG IR instruction scan-path length failed.
The many-ones plus many-zeros tested length was -8208 bits.
The many-zeros plus many-ones tested length was 8192 bits.
The test for the JTAG DR bypass scan-path length failed.
The many-ones plus many-zeros tested length was -8208 bits.
The many-zeros plus many-ones tested length was 8192 bits.
Freed all scan-controller memory.
The scan-path lengths are invalid.
The measured lengths indicate that an error exists
in the configuration of the link-delay or scan-path.
---[Close the controller]---------------------------------------
Requesting Unified-SCIF to close the controller.
The controller has been closed successfully.
---[An error has occurred and this utility has aborted]---------
This error was generated by TI's USCIF driver.
The decimal value is: `-234'.
The title string is: `SC_ERR_PTH_LENGTH'.
The explanation is:
The two JTAG scan-paths have invalid lengths.
This indicates that an error exists in the
configuration of the link-delay or scan-path.
E-mail: 
info@telesys.ru
