[an error occurred while processing this directive]
|
-----[Select the controller]-------------------------------------------------
This utility has selected a classic XDS510 emulator.
This utility will operate on port address '0x0'.
That original port address was aliased to '0x0240'.
The controller has an insertion length of '16' (0x0010).
The controller has a revision number of '1' (0x0001).
The controller type is 'The venerable TBC (74ACT8990)'.
The local memory has a base address of '0' (0x000000).
The local memory has a word capacity of '262144' (0x040000).
-----[Perform the scan-path length test on the JTAG IR and DR]---------------
This scan-path test uses blocks of 512 32-bit words.
The test for the JTAG IR instruction scan-path length succeeded.
The JTAG IR instruction scan-path length is 50 bits.
The test for the JTAG DR bypass scan-path length succeeded.
The JTAG DR bypass scan-path length is 3 bits.
-----[Perform the scan-path integrity test on the JTAG IR]-------------------
This scan-path test uses blocks of 512 32-bit words.
Starting an Integrity Test using 0xFFFFFFFF.
All of the 32-bit data values were scanned correctly.
Finished that Integrity Test.
Starting an Integrity Test using 0x00000000.
All of the 32-bit data values were scanned correctly.
Finished that Integrity Test.
Starting an Integrity Test using 0xFE03E0E2.
All of the 32-bit data values were scanned correctly.
Finished that Integrity Test.
Starting an Integrity Test using 0x01FC1F1D.
All of the 32-bit data values were scanned correctly.
Finished that Integrity Test.
Starting an Integrity Test using 0x5533CCAA.
All of the 32-bit data values were scanned correctly.
Finished that Integrity Test.
Starting an Integrity Test using 0xAACC3355.
All of the 32-bit data values were scanned correctly.
Finished that Integrity Test.
The JTAG IR integrity test has succeeded.
-----[Perform the scan-path integrity test on the JTAG DR]-------------------
This scan-path test uses blocks of 512 32-bit words.
Starting an Integrity Test using 0xFFFFFFFF.
All of the 32-bit data values were scanned correctly.
Finished that Integrity Test.
Starting an Integrity Test using 0x00000000.
All of the 32-bit data values were scanned correctly.
Finished that Integrity Test.
Starting an Integrity Test using 0xFE03E0E2.
All of the 32-bit data values were scanned correctly.
Finished that Integrity Test.
Starting an Integrity Test using 0x01FC1F1D.
All of the 32-bit data values were scanned correctly.
Finished that Integrity Test.
Starting an Integrity Test using 0x5533CCAA.
All of the 32-bit data values were scanned correctly.
Finished that Integrity Test.
Starting an Integrity Test using 0xAACC3355.
All of the 32-bit data values were scanned correctly.
Finished that Integrity Test.
The JTAG DR integrity test has succeeded.
E-mail: info@telesys.ru