|
|
Привет.
Спаял 2 эмулятора, PCI плата в системе нашлась, драйвера поставилсь.
установил SA 1.1 на POD'е в разомкнутое состояние (в замкнутом состоянии вообще не работает)
подключил эмулятор к eZdsp TMS320F2812
установил клоки и задержку при помощи sm510ctl.exe
xdsprobe.exe -r Пишет, что успешно проресетил контроллер
xdsprobe.exe -y иногда говорит, что встречается одна ошибка, чаще говорит, что без ошибок,
xdsprobe.exe -i, дамп такой:
---[The scan-path lengths of TI DSP's and microcontrollers]-----
The JTAG IR register for a ARM7 or ARM9 device has 4 bits.
The JTAG IR register for a `classic' TI DSP device has 8 bits.
The JTAG IR register for a `IceMaker' TI DSP device has 38 bits.
The JTAG IR register for a C621x or C671x device has 46 bits.
The older TI DSP devices with `classic' emulation
include the C4x, C5x, C8x, C20x, C24x products.
The newer TI DSP devices with `classic' emulation
include the VC33, C54x, C620x and C670x products.
The TI DSP devices with `IceMaker' emulation
include the C27x, C28x, C55x and C64x products.
---[Perform the scan-path length test on the JTAG IR and DR]----
The test for the JTAG IR instruction scan-path length failed.
The many-ones then many-zeros tested length was -16400 bits.
The many-zeros then many-ones tested length was -16387 bits.
The test for the JTAG DR bypass scan-path length failed.
The many-ones then many-zeros tested length was -14432 bits.
The many-zeros then many-ones tested length was -15667 bits.
The measured scan-path lengths are invalid.
The specific values -16387 and -15667 indicate that an error
exists in the configuration of the link-delay or scan-path.
---[An error has occurred and this utility has aborted]---------
This error is generated by TI's USCIF driver.
The error's value is: `-234'.
The error's title is: `SC_ERR_PTH_MEASURE'.
The error's explanation is:
The measured lengths of the two JTAG scan-paths
are invalid. This indicates that an error exists
in the configuration of the link-delay or scan-path.
Вопрос, как устранить эту ошибку ?
E-mail: 
info@telesys.ru
