[an error occurred while processing this directive]
|
Использую TMS320vc5502 и JTAG-эмулятор SDSP-510PCI.
В перед запуском CCS (использую Code Composer Studio 3.1) в CCS setup настраиваю конфигурацию системы как С5502 XDS510 Emulator
По настройкам эмулятора все по описанию...
рпоцессор (TMS320vc5502 ) установлен на плату и запитан как положено: i/o=3.3V, ядро=1,26V
При включении CCS 3.1 пишет, что проц (TMS) не подключен.
При попытке подключить программно через вкладку в CCS выдаются следующие ошибки:
=======================================
1->
Error connecting to the target:
Error 0x80000240/-180
Fatal Error during: Initialization, OCS,
This error was generated by TI's USCIF driver.
SC_ERR_CTL_NO_TRG_POWER <-180>
The controller has detected a target power loss.
The user may have failed to turn-on or connect its source.
Sequence ID: 0
Error Code: -180
Error Class: 0x80000240
I/O Port = 240
Board Name: C5502 XDS510 Emulator
Cpu Name: CPU_1
Abort: Close Code Composer Studio.
Retry: Try to connect to the target again.
Cancel: Remain disconnected from the target
Diagnostic: Run diagnostic utility.
или 2->
Error connecting to the target:
Error 0x80002240/-121
Fatal Error during: Initialization, OCS, Control,
This error was generated by TI's USCIF driver.
SC_ERR_CMD_HANDLE <-121>
A bad controller handle has been given to a function,
either before attempting to open the controller, or after
having opened the controller and ignored its error status.
Valid controller handles are generated when attempts
to open the controller return a clean error status.
Sequence ID: 0
Error Code: -121
Error Class: 0x80002240
I/O Port = 240
Board Name: C5502 XDS510 Emulator
Cpu Name: CPU_1
Abort: Close Code Composer Studio.
Retry: Try to connect to the target again.
Cancel: Remain disconnected from the target
Diagnostic: Run diagnostic utility.
======================================
При попытке RESETнуть эмулятор программно через вкладку в CCS, выводится лог:
... can't open controller... (всё полностью сообщение сейчас не помню)
Поделитесь пожалуйста соображениями, в чем может быть дело, как устранить...
Спасибо
E-mail: info@telesys.ru