[an error occurred while processing this directive]
|
А на счёт отключения так цитирую.
TDO: If boundary scan is used, this pin is the Test Data Output. If boundary scan is not used, this pin is a 3-state output without a register, after configuration is completed. This pin can be user output only when called out by special schematic definitions. To use this pin, place the library component TDO instead of the usual pad symbol. An out-put buffer must still be used.
Если я правильно понял то после конфигурации он перестаёт быть доступным. Т.е. как только я законфигурировал кристалл я потерял с ним связь :(
E-mail: info@telesys.ru