[an error occurred while processing this directive]
|
Вначале EPC1441 удерживает OE-nSTATUS:
Before configuration begins, the configuration device issues a POR delay of 200 ms (maximum) to allow the power supply to stabilize; during this time, the configuration device drives its OE pin low.
...
When exiting power-on reset (POR), both the target and configuration device release the open-drain nSTATUS pin.
Затем EPF10K может выставить 0 при ошибке:
If an error occurs during configuration, nSTATUS is pulled low by the target device.
Предложение такое. Разорвать связь OE-nSTATUS (в этом случае со стороны EPC и со стороны EPF должен быть свой pull-up), и посмотреть - кто держит 0.
E-mail: info@telesys.ru