Разработка, производство и продажа радиоэлектронной аппаратуры
|
Требуется программист в Зеленограде - обработка данных с датчиков; ColdFire; 40 тыс.
e-mail: jobsmp@pochta.ru
|
Full Swing Crystal
Oscillator
Pins XTAL1 and XTAL2 are input and output, respectively, of an inverting amplifier
which can be configured for use as an On-chip Oscillator, as shown in Figure 13. Either
a quartz crystal or a ceramic resonator may be used.
This Crystal Oscillator is a full swing oscillator, with rail-to-rail swing on the XTAL2 output.
This is useful for driving other clock inputs and in noisy environments. The current
consumption is higher than the “Low Power Crystal Oscillator” on page 26. Note that the
Full Swing Crystal Oscillator will only operate for VCC = 2.7 - 5.5 volts.
C1 and C2 should always be equal for both crystals and resonators. The optimal value
of the capacitors depends on the crystal or resonator in use, the amount of stray capacitance,
and the electromagnetic noise of the environment. Some initial guidelines for
choosing capacitors for use with crystals are given in Table 9. For ceramic resonators,
the capacitor values given by the manufacturer should be used.
The operating mode is selected by the fuses CKSEL3..1 as shown in Table 8.
Составить ответ | Вернуться на конференцию
Ответы