[an error occurred while processing this directive]
|
1. Не могу перевести абзац:
Note: During internal operation, Busy Flag (DB7) is read “High”.
Busy Flag check must be preceded by the next instruction.
When an MPU program with checking the Busy Flag (DB7) is made, it must be necessary 1/2 fosc
for executing the next instruction by the falling edge of the 'E' signal after the Busy Flag (DB7) goes to
“Low”.
Помогите.
2. При зависи в DDRAM значения 0x1B (ESC), все куда-то деется, ни какой реакции на последующие данные, помогает только ClearDisplay
Может я чего ни так понимаю???
E-mail: info@telesys.ru