|
/* Moving LED example
CodeVisionAVR C Compiler
(C) 2000-2002 HP InfoTech S.R.L.
www.hpinfotech.ro
Chip: AT90S8515
Memory Model: SMALL
Data Stack Size: 128 bytes
8 LEDs are connected between the PORTC
outputs and +5V using 1K current
limiting resistors
The LEDs anodes are connected to +5V
On the STK500 it's only necessary to
connect the PORTC and LEDS headers
together with a 10-wire cable
*/
// I/O register definitions for AT90S8515
#include <90s8515.h>
// quartz crystal frquency [Hz]
#define xtal 3686400
// moving LED frequency [Hz]
#define fmove 2
// the LED on PORTC output 0 will be on
unsigned char led_status=0xfe;
// TIMER1 overflow interrupt service routine
// occurs every 0.5 seconds
interrupt [TIM1_OVF] void timer1_overflow(void)
{
// preset again TIMER1
TCNT1=0x10000-(xtal/1024/fmove);
// move the LED
led_status<<=1;
led_status|=1;
if (led_status==0xff) led_status=0xfe;
// turn on the LED
PORTC=led_status;
}
void main(void)
{
// set the I/O ports
// all PORTC pins are outputs
DDRC=0xff;
// turn on the first LED
PORTC=led_status;
// init TIMER1
// TIMER1 is disconnected from pin OC1
// no PWM
TCCR1A=0;
// TIMER1 clock is xtal/1024
TCCR1B=5;
// preset TIMER1
TCNT1=0x10000-(xtal/1024/fmove);
// clear TIMER1 interrupts flags
TIFR=0;
// enable TIMER1 overflow interrupt
TIMSK=0x80;
// all other interrupt sources are disabled
GIMSK=0;
// global enable interrupts
#asm
sei
#endasm
// the rest is done by TIMER1 overflow interrupts
while (1);
}
E-mail: info@telesys.ru