Помогите, пожалуйста, понять смысл предложения (это из описания механизма In-Application Programming для AT91SAM9XExxx):
Отправлено
Igor_Koval (95.132.210.200) 28 января 2010, г. 13:49
"When called, the In Application Programming (IAP) function sends the desired FLASH command to the EFC and waits for the FLASH to be ready (looping while the FRDY bit is not set in EFC_FSR register). Since this function is executing from ROM, this allows FLASH programming (like page programming) to be done by code running out of FLASH and no more out of SRAM which eases the software engineer IAP development. The IAP function entry point is retrieved by reading the SWI vector in ROM (see product datasheet to get SWI vector address in ROM)."